ATL P-3.5G-06-H front-end heightening headphone
upgrade line gold-plated plug.
ATL launches a variety of high-quality audio levels "AUDIO GRADE" with headphones enthusiasts.
Headphone plug-in! As a quest for the highest quality and high quality headphones enthusiasts you can not miss!
The highest grade of 24K gold plated using. ATL is the most obvious plug after the industry replacement of the same grade..
Range open / tri-band equalization / high-frequency fine / IF sweet and thick / low-frequency full.
Voice performance without losing bandwidth and analysis, showing soft charm.
The appearance of the mirror black paint noble / fashion / beautiful can be a perfect match with the appearance of all kinds of wire.
ATL P-3.5G-06-H entry diameter : 6.0mm.
Shell : Brass mirror black paint.
Substrate : Brass Gold Plated.
Negative electrode : Brass gold plated.
In line diameter : 6.0mm.
It is recommended to prepare the ATL P-3.5G-06-H male plug into the female seat and then measure the positive and negative poles before welding.
In this way, the center pin of the P-3.5G-06-H plug has been fixed to the mother seat, and the displacement and heat dissipation of the plug will improve and increase the yield.
Matters needing attention:
After the welding is completed, measure the P-3.5G-06-H plug and the 3.5mm female connector again and remove the 3.5mm female connector or earphone 3-5 minutes after the continuity test.
Please use a small wattage soldering iron to solder with 0.5mm wire solder or less and avoid contact with the P-3.5G-06-H male plug for too long.